|
ENGINE FACTORY .COM Let's Build a 427 Ford Stroker Engine Together!
|
||||
 |
Each part is computer generated and analyzed to make sure they are all compatible; Machine worked to obtain proper clearance. |
|
|
Explanation of High Lift Large Duration Roller Cam Shaft, Warning Regarding Cam Gear Compatibility, Timing Chain and Timing Cover Installation. |
|
|
Installation of Oil Pump, Roller Lifters, Lifter Harness, Harden Pushrods, and Guide Plate to Push Rod Warning. |
|
Block shown with Power Forged Pistons, Deck Surface, Front Sump Pan, and Timing Cover Installed. Roller Lifters and Cylinder Head Bolts. |
|
|
|
Proper Head Gasket Installation Left and Right, Head Installation on Alignment Pins and Lifter Harness Installed. |
|
Roller Rocker Arm Installation, along with Precision Valve Geometry and Valve Adjustment. |
|
|
|
Checking the Valve Spring's for Coil Bind, Installation of Air Gap Intake Along with Gaskets and End Seals. |
|
Carburetor Installation and Adjustments, Valve Cover and Baffle Warning, Thermostat and Housing Installation. |
|
|
|
Harmonic Balancer Bolt Patterns, Both 3-bolt and 4-bolt Systems, along with Timing Pointer Installation. |
|
Fuel Pump and Braided Line Installation, Different Flywheels and Different Balance, along with Dip Stick and Distributor Installation.
|
|
|
|
Installation of Coil and Wiring, Low Profile Air Cleaner, Serpentine System with 100AMP Alternator. |
Best if viewed in numerical order |
||